Alcatel-Lucent 1665 Installation Manual page 154

Data multiplexer extend (dmxtend)
Hide thumbs Also See for 1665:
Table of Contents

Advertisement

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with the
LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then
proceed to
Note:
provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Remove the second LNW62 or LNW55 from the packing material.
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot D2 or G2 as required).
........................................................................................................................................................................................................................
7
Repeat
equipped with LNW62 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in the
E
O
N D
........................................................................................................................................................
LNW63 (GBE PL) 4 port or LNW64 (GBE PL) 8-port installation (optional)
Follow this procedure only if installing LNW63 (GBE PL) 4 port or LNW64 (GBE PL) 8
port circuit packs into the Alcatel-Lucent 1665 DMXtend shelf.
Note:
interface. This procedure consists of two parts. Installing the circuit card and installing
the PTM per
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slot (D1 or G1)
where the LNW63 or LNW64 circuit pack will be installed.
Note:
group unless the LNW141 or LNW84 VLF main OLIU is used. See Alcatel-Lucent
............................................................................................................................................................................................................................................................
4 - 2 0
Step
7.
177D or LNW98 Apparatus Blanks are required in all unused slots D and G to
Step 7
through
Step 6
S
F
T E P S
The LNW63 or LNW64 circuit packs require PTM modules for the Ethernet
Appendix
B,
LNW63 or LNW64 circuit pack can only be installed in slot 1 of any function
for each additional function group and/or growth slot to be
Table I-2, Installation
Install pluggable modules (p.
Step
5. If not, install a 177D or
checklist.
B-8).
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013

Advertisement

Table of Contents
loading

Table of Contents