Alcatel-Lucent 1665 Installation Manual page 234

Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
7 Protection Switch Mode
In the
........................................................................................................................................................................................................................
8 Apply
Click
Result:
indication.
........................................................................................................................................................................................................................
9
Verify the active path, with the
Result:
a ABN condition will be displayed on the GUI.
........................................................................................................................................................................................................................
10
Clear the manual switch.
........................................................................................................................................................................................................................
11
Click on the
........................................................................................................................................................................................................................
12
Double Click on a path; e.g.,
........................................................................................................................................................................................................................
13
Observe the
........................................................................................................................................................................................................................
14 Protection Switch Mode
In the
........................................................................................................................................................................................................................
15
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
Function units/growth slots switching test
This test will initiate switching commands from the CIT and verify proper switching and
LED indications.
Note:
pair.
............................................................................................................................................................................................................................................................
6 - 5 0
to issue the command.
The Response Window should display the command followed by a COMPLD
The path selected in the previous steps will have switched to the other path and
Fault > Protection Switch > Path Protection
Path m1-1a1-1-1
Active Path
displayed.
S
F T E P S
This procedure should be performed on each function unit and/or growth slot
pull down window select
View > Protection > Path Protection
.
pull down window select
"Installation checklist" (p.
Manual
.
command.
.
Clear
.
II-5).
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013