............................................................................................................................................................................................................................................................

Place the circuit pack into the shelf (slot D2 or G2 as required). Do NOT engage the

circuit pack in the backplane connector.

Repeat

LNW16 or LNW19B circuit packs.

Check off the appropriate box in the

N D

........................................................................................................................................................

LNW18 (12TMUX) and LNW20 (48TMUXDS3EC1) installation (optional)

Follow this procedure only if installing LNW18 (12TMUX) or LNW20

(48TMUXDS3EC1) into the Alcatel-Lucent 1665 DMXtend shelf.

See the engineering job specification. Identify the proper function group(s) where LNW18

or LNW20 will be installed.

Remove the LNW18 or LNW20 from the packing material.

Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the

circuit pack in the backplane connector.

If a protection circuit pack is required, continue with the

LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then

proceed to

Important!

to provide proper air flow for cooling.

Remove the second LNW18 or LNW20 from the packing material.

4 - 1 4

Step 1

through

Step 6

T E P S

Step

177D or LNW98 Apparatus Blanks are required in all unused slots D and G

for each additional function group to be equipped with

"Installation checklist" (p.

I-6).

Step

5. If not, install a 177D or

Alcatel-Lucent 1665 DMXtend R10.0

365-372-327R10.0 Issue 1

January 2013

Table of Contents

Alcatel-Lucent 1665 Installation Manual page 148

Related Manuals for Alcatel-Lucent 1665

Related Products for Alcatel-Lucent 1665

Table of Contents