Stand-alone node setup
........................................................................................................................................................................
prompt on the computer, and type the command ipconfig/all. The command will show
an IP address line. If there is no address line or 0.0.0.0 for an IP address, then you must
assign an IP address to the NIC card of the computer.
................................................................................................................................................
2
Start the WaveStar
was created by the installation procedure.
The following windows appear:
........................................................................................................................................................................
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013
®
CIT software on the PC by double clicking on the WaveStar
®
icon that
5 - 7