Alcatel-Lucent 1665 Installation Manual page 146

Circuit pack installation
............................................................................................................................................................................................................................................................
Important!
LNW95 apparatus blank to provide proper air flow for cooling. For LNW141 or LNW84
main OLIUs the center divider must be removed and in the unused slot a LNW98
apparatus blanks installed to provide proper air flow for cooling.
........................................................................................................................................................................................................................
7
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
LNW7 (28DS1PM) and LNW8/LNW801 (56DS1E1) installation (optional)
Follow this procedure only if installing LNW7 (28DS1PM) or LNW8/LNW801
(56DS1E1) circuit packs into the Alcatel-Lucent 1665 DMXtend shelf.
Note:
is used.
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slots where
LNW7, LNW8, or LNW801 circuit packs will be installed.
Note:
directly interchangable. Therefore, an LNW8 and an LNW801 can occupy companion
slots at the same time.
........................................................................................................................................................................................................................
2
Remove the LNW7, LNW8, or LNW801 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a protection circuit pack is required, continue with
LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then
proceed to
Important!
to provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Remove the second LNW7, LNW8 or LNW801 from the packing material.
............................................................................................................................................................................................................................................................
4 - 1 2
If any of the main slots are to remain unequipped, install a LNW42 or
S
F T E P S
The LNW7 is not supported when the LNW141 or LNW84 VLF main OLIU
The LNW8/LNW801 circuit packs have common functionality and they are
Step 8.
177D or LNW98 Apparatus Blanks are required in all unused slots D and G
"Installation checklist" (p.
Step 5
I-6).
If not, install a 177D or
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013