Alcatel-Lucent 1665 Installation Manual page 200

Stand-alone installation testing
............................................................................................................................................................................................................................................................
Verify provisioning
This procedure will verify provisioning.
........................................................................................................................................................................................................................
1
For the LNW16 or LNW19B, verify that all ports are provisioned for DS3.
Use the
........................................................................................................................................................................................................................
2
Click on each DS3 port
Result:
........................................................................................................................................................................................................................
3
To provision a port to DS3, from the GUI choose Configuration:Equipment Select the
DS3 port, click Select.
........................................................................................................................................................................................................................
4
Choose Electrical Interface Type = DS3:Signal Format = Framed.
........................................................................................................................................................................................................................
5 Apply
Click
........................................................................................................................................................................................................................
6
Repeat
LNW19B circuit pack(s).
E O
N D
........................................................................................................................................................
Transmission test
Perform the remaining steps in this procedure for all Function Groups equipped with
LNW16 (12DS3/EC1), LNW19B (48DS3/EC1) or LNW39/LNW391/LNW84
(DS1/DS3/16/3) circuit packs.
........................................................................................................................................................................................................................
1
Set the DS3 test set to transmit and receive a framed Pseudo Random Bit Stream (PRBS)
DS3 test signal CBIT or M13 (M13 is default).
M13 should be used to test LNW39/LNW391/LNW84 (DS1/DS3/16/3).
............................................................................................................................................................................................................................................................
6 - 1 6
GUI View:Equipment
All ports are provisioned as DS3.
to issue the command.
Step 1 through Step 5
S
F T E P S
command.
for each Function Group equipped with LNW16 or
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013