Alcatel-Lucent 1665 Installation Manual page 150

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
7
Repeat
equipped with LNW31 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
LNW37 (OC-3 4 port PTM OLIU), LNW45 (OC-3 8 port PTM OLIU), or LNW603 (OC-192 PTM OLIU)
low-speed installation
Follow this procedure if installing the LNW37 (OC-3 4 port PTM OLIU), LNW45 (OC-3
8 port PTM OLIU), or LNW603 (OC-192 PTM OLIU) circuit packs into the Alcatel-
Lucent 1665 DMXtend shelf.
Note:
with one box containing the circuit pack, and the other containing the ordered quantity
of PTMs. This procedure will consist of two parts.
– Install the circuit card
– Install the PTM.
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group(s) and/or growth
slot(s) where the ircuit pack will be installed.
........................................................................................................................................................................................................................
2
Remove the pack from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with
LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then
proceed to
Important!
to provide proper air flow for cooling.
............................................................................................................................................................................................................................................................
4 - 1 6
Step 1 through Step 6
S
F T E P S
The LNW37, LNW45, and LNW603 circuit pack comes in separate boxes,
Step 7.
177D or LNW98 Apparatus Blanks are required in all unused slots D and G
for each additional function group and/or growth slot to be
Table I-2, Installation checklist.
Step 5. If not, install a 177D or
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013