........................................................................................................................................................................

................................................................................................................................................

At the far end, connect the input optical fiber to the proper OLIU IN connector.

Result:

................................................................................................................................................

At the near end, connect the input optical fiber to the proper OLIU IN connector.

Result:

................................................................................................................................................

Disconnect the fiber cable from the OUT connector on the OLIU at one end of the span.

At the other end, verify that the associated FAULT LED is flashing, indicating a loss of

signal. Reconnect the fiber and repeat the process for the other direction of transmission.

................................................................................................................................................

In order to enable communications with the adjacent Alcatel-Lucent 1665 DMXtend

nodes,

................................................................................................................................................

Use the

................................................................................................................................................

Configure DCC Terminations

The

................................................................................................................................................

Port AID:

For

................................................................................................................................................

OSI Over DCC

For

................................................................................................................................................

LAPD Roll:

For

................................................................................................................................................

Click Apply to send the command.

................................................................................................................................................

Port AID:

For

................................................................................................................................................

OSI Over DCC

For

........................................................................................................................................................................

7 - 8

The FAULT LED on the OLIU extinguishes.

GUI

to turn off the DCCs.

select dcc-m1-1

enabled

select

user-side

select

select dcc-m2-1.

enabled

select