Alcatel-Lucent 1665 Installation Manual page 156

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
2
Remove the LNW73/73C from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a 177D or LNW98 Apparatus Blank into the companion circuit pack slot (D2 or G2
as required).
Important!
to provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Repeat
LNW73 or 73C circuit packs.
........................................................................................................................................................................................................................
6
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
LNW74 (10/100T/F), LNW87 (FE/GBE PL), or LNW910 (FE/GBE/10GBE) installation (optional)
Follow this procedure if installing an LNW74 (10/100T/F), LNW87 (
LNW910 (FE/GBE/10GBE) circuit pacs in the Alcatel-Lucent 1665 DMXtend shelf.
Note:
Ethernet interface. This procedure consists of two parts. Installing the circuit card and
installing the PTM per
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slot (D1 or G1)
where the LNW74, LNW87, or LNW910 circuit pack will be installed.
Note:
function group. The LNW74 or LNW87 can be installed into any function slots (D1,
D2, G1 or G2) if the LNW141 or LNW84 VLF main OLIU is used. See Alcatel-
............................................................................................................................................................................................................................................................
4 - 2 2
177D or LNW98 Apparatus Blanks are required in all unused slots D and G
Step 1 through Step 4
S
F T E P S
The LNW74, LNW87, or LNW910 circuit packs require PTM modules for the
Appendix
The LNW74 or LNW87 circuit pack can only be installed in slot 1 of any
for each additional function group to be equipped with
Table I-2, Installation
B, Install pluggable modules (p.
checklist.
FE/GBE PL), or
B-8).
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013