Omron ZJ-SD Series User Manual page 9

Editor's Note
Page Format
Using the Hold Functions Using the Hold Functions
The "hold functions" hold data for specific points during the measurement period, such as the
minimum and maximum values, and output those values after measurement ends.
• Flow of Operation
2
1
Selecting the Hold Setting the Trigger
Condition for for Measurement in
Measured Values the Hold Mode
Selecting the Hold Condition for Measured Values Selecting the Hold Condition for Measured Values
The time period from the start to the end of hold measurements is called the "sampling
period."
The value to be held during that sampling period is selected here.
After sampling is started, the CLAMP value is output until the first sampling period ends.
What is the "CLAMP value?" p.73
Moving to the FUN mode and HOLD
1. 1.
Set the mode switch to FUN.
2. 2.
Use the LEFT and RIGHT keys to display
[HOLD] on the main display.
Selecting the hold condition
3. 3.
Press the UP or DOWN key.
The sub-display flashes.
4. 4.
Use the UP and DOWN keys to select the
desired hold condition.
5. 5.
Press the ENT key to confirm the setting.
This registers the setting.
● Operation procedure and supplementary explanation
Explains the operation procedure and the display
status resulting from execution of the operation.
Helpful information regarding operation and
reference pages is introduced here using symbols.
Section 5 Section 5
Using the Hold Functions Using the Hold Functions
3
4
(if required)
(if required)
Set the Trigger
Setting the Delay
Direction and
Time
Self-trigger Level
ZJ-SD ZJ-SD
53 53
User's Manual User's Manual
● Display
Shows the display status resulting from the operation.
● Keys or switches to be used
Illustrates the keys and switches to be used.
Introduction
Editor's Note
● Title of each section
● Header
Indicates the contents of the page.
● Overview
Describes the overview and
operation flow of the section.
● Cross-header
● Overview and points of
the function described
● Index label
Shows the chapter number
and contents.
● Purpose of operation
Shows the contents of the
operation to be performed.
* This page does not exist.
ZJ-SD
vii
User's Manual