Condition Settings
Display the target function on the main display and select the desired setting value from
the sub-display to set measurement conditions.
This section describes how to set measurement conditions, using an example of
setting a peak hold as the hold condition.
Moving to FUN mode and HOLD
1.
Set the mode switch to FUN.
2.
Use the LEFT and RIGHT keys to display
[HOLD] on the main display.
Setting Hold Conditions
3.
Press the UP or DOWN key.
The sub-display flashes.
4.
Use the UP and DOWN keys to select [P-H].
Press either the LEFT or RIGHT key to cancel the
selected option.
The display returns to the current setting ([OFF] in this
example).
5.
Press the ENT key to confirm the settings.
This registers the setting.
Basic Knowledge for Operation
Section 3
ZJ-SD
31
User's Manual