Omron ZJ-SD Series User Manual page 138

Section 7
Communicating with the Static Electricity Smart Monitor via the Interface Unit
Communicating with the Static Electricity
Smart Monitor via the Interface Unit
The following describes the procedure for connecting the Amplifier Unit to a personal
computer via an Interface Unit to enable use of the Static Electricity Smart Monitor.
1.
Install the Static Electricity Smart Monitor on the personal computer.
2.
Check that the current/voltage switch on the
base of the Interface Unit is set to the side
that has no tab (default).
3.
Set the Amplifier Unit to the RUN mode.
Switching Modes p.28
4.
Connect the Interface Unit and personal computer with a cable.
To connect to a personal computer (PC/AT compatible), use a 9-pin D-sub cross cable (female to female).
p.122
5.
Connect the Interface Unit to the Amplifier Unit.
Use of a calculating unit (ZX-CAL2) allows connection of up to five Amplifier Units.
If you want to connect different types of Amplifier Units, such as ZJ-SDA11 and ZX-E series, contact
your OMRON representative.
ZJ-SD
124
User's Manual
Connection Method p.22
Side with no tab