Omron ZJ-SD Series User Manual page 118

Section 6
Changing Display Scales
3.
Press any cursor key.
The current measured value is displayed on the main
display.
The leftmost digit of the sub-display flashes.
4.
Use the cursor keys to set the offset for the
measured value.
The decimal point position can be changed as follows.
5.
Press the ENT key to confirm the setting.
The decimal point flashes.
6.
Use the LEFT and RIGHT keys to move the
decimal point.
7.
Press the ENT key to confirm the setting.
Confirming completion of scaling settings
If scaling has been completed correctly, the display
indicates [OK].
If scaling was not possible, the display indicates [NG].
Check the following points and then execute scaling
again.
• Is the ENABLE indicator lit?
• Are the two points separated by at least 1% of the rated
measurement range?
ZJ-SD
104
User's Manual
Moves from one digit to
another.
Changes the numeric value.