Omron ZJ-SD Series User Manual page 43

Reading Displays
The data displayed on the main and sub-displays depends on the currently selected
mode. The sensor is already set to the RUN mode before it was shipped from the
factory.
When the power is turned ON, the model of the Amplifier Unit is displayed on the main
display followed by the number of channels.
The software version is on the sub-display.
This information is displayed for approx. three seconds, followed by the data for each
mode.
Main Display
Sub-display
Mode Main display
RUN Displays the measured value (the value
after the measurement conditions have
been reflected).
For example, when the hold function is
set, the held value is displayed.
T Displays the measured value (the value
after the measurement conditions have
been reflected).
For example, when the hold function is
set, the held value is displayed.
FUN Displays the function names in order
when the Control Keys are pressed.
Function Transition Charts p.33
POWER
kV
Displays the threshold value, voltage, current,
resolution, distance and present value in order when the
Control Keys are pressed.
Threshold Value Display
Displays either the HIGH or LOW threshold value,
depending on the position of the threshold
switch.
Displays the threshold value for the threshold that is
being set.
Displays either the HIGH or LOW threshold value,
depending on the position of the threshold
switch.
Displays the setting value for the function displayed on
the main display.
Basic Knowledge for Operation
Sub-display
Section 3
ZJ-SD
29
User's Manual