Table of Contents
Advertisement
Section 2
Mounting on the Mounting Bracket
Example of mounting the ZX-UD__
■
1.
Fix the ZX-UD__ onto the mounting bracket (ZJ-XBU1) using the M18 tightening nut.
Tighten by holding the
M18 tightening nut
(supplied) between your
fingers to secure.
The nut must be tightened with a torque of 45 Nm or less.
2.
Fix the ZJ-S___ using the screws.
Do not allow anything to touch the metal case of the Sensor Head. Failure to do so might prevent accurate
measurement by the sensor.
ZJ-SD
18
User's Manual
Wave
emitting/receiving
section
18.5 mm dia.
(+0.5/0)
Advertisement
Table of Contents
