Connections - Omron ZJ-SD Series User Manual

Connections

This section describes how to connect component parts of the Smart Sensor.
Before connecting/disconnecting Smart Sensor components, make sure that the power to the Amplifier Unit
is turned OFF. The Smart Sensor may malfunction if components are connected or removed while the power
is ON.
Sensor Head
Do not touch the terminals inside the connector.
■ Connecting the Sensor Head
Push the Sensor Head connector into the Amplifier Unit connector until it locks.
■ Disconnecting the Sensor Head
To disconnect the Sensor Head, hold the Sensor Head's connector ring and the
Amplifier Unit connector, and then pull them straight out.
• Be sure to hold the connector of the Amplifier Unit to disconnect it. Failure to do so may damage
the input cable of the Amplifier Unit.
• Do not touch the terminals inside the connector.
Connector Ring
All settings on the Amplifier Unit will be cleared if the Sensor Head is replaced with a different type.
Section 2
Connections
ZJ-SD
19
User's Manual