TABLE 9–4
Pin Pair
E1
E2
E3
E4
E5
E6
E7
E8
Installing a Hard Disk Drive
To install a hard disk:
1. Refer to Figure 9–10.
2. Determine which type of disk drive mounting bracket you have.
a. If the disk drive bracket does not have grommets, continue with Step 3.
b. If the disk drive bracket has grommets, skip Step 3 and move on to Step 4.
3. For a drive bracket without grommets, partially insert the standard mounting
screws into the drive screw holes.
Use the holes that are closest to the corners of the drive. Now skip ahead to Step 5.
4. If the drive bracket has grommets, insert a shoulder screw into each grommet,
leaving enough clearance for the drive to be lowered into the bracket.
5. Lower the hard drive into the bracket and tighten the four screws.
SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual ♦ Revision A, November 1993
88
1.0-Gbyte Conner Drive Configuration Jumpers
Description
SCSI ID address
SCSI ID address
SCSI ID address
(Reserved)
Motor enable
Delay spin
Disable parity
SCSI bus power termination
Factory Set
Yes
Yes
No
No
Yes
No
No
No