Port 0 (P0.0-P0.3); Port 0 Configuration; Port 0 Registers - Oki ML63611 User Manual

ML63611 User's Manual
Chapter 10 Ports (INPUT, I/O PORT)
10.3 Port 0 (P0.0–P0.3)
The ML63611 has Port 0, a 4-bit input-only port.
Apart from the input port function, Port 0 has the functions of external interrupts and the function of transfer to
system reset due to simultaneous key depression.

10.3.1 Port 0 Configuration

For the input port functions, there are the input modes of input with pull-up resistor, input with pull-down resistor,
and high impedance, which can be selected by the Port 0 control registers 0/1 (P0CON0 and P0CON1). Among
the external interrupt functions, the external 5 interrupt function has been assigned to this port which detects the
OR result of the four input bits. It is possible to set the interrupt enabling and disabling for each bit using the Port
0 interrupt enable register (P0IE).
The function of transfer to system reset due to simultaneous key depression is the function of transferring to the
system reset mode when there is simultaneous key depression of 2 bits, 3 bits, or 4 bits, as specified by the mask
option, for a period of more than about 2 to 3 seconds. For details, see Section 3.2, "System Reset Mode (RST)".
Figure 10-1 shows the configuration of port 0.
P0.0–P0.3

10.3.2 Port 0 Registers

The following registers are used to control port 0:
(1) Port 0 data register (P0D)
(2) Port 0 control registers 0/1 (P0CON0, P0CON1)
(3) Port 0 interrupt enable register (P0IE)
(1) Port 0 data register (P0D)
P0D is a 4-bit read-only special function register (SFR) used to read the pin level of each bit of port 0.
Pin level of each bit of port 0
0: "L" level (initial value)
1: "H" level
OPTION A (C): 1.5 V (3.0 V), Without regulator
circuit for LCD bias
V
DD
V
SS
4
Figure 10-1 Input-Only Port (Port 0) Configuration
bit 3
P0D (000H)
P03
(R)
Pull-up/
pull-down
P0CON0
control
P0CON1
Read P0D
4
bit 2
P02
10 – 2
Data bus
4
4
4
P0.0–P0.3
(to external interrupt 5
control circuit)
bit 1 bit 0
P01 P00
OPTION B (D): 1.5 V (3.0 V), With regulator
circuit for LCD bias