Thread Trimming; Trimming Pressure Between Knives - Dürkopp Adler 52 i Series Service Instructions Manual

Thread trimming

9

9.1 Trimming pressure between knives

Proper setting
The trimming pressure should be as large as possible, however, the
knives should be on touch within the last part of the trimming knife path
only.
Pic. 35: Trimming pressure between knives
(1) - Screw
(2) - Bolt
1. Tilt the machine ( p. 12).
2. Loosen the screw (1) and remove the bolt (2).
3. Set a high pressure between the trimming knives with the screw (3) so
4. Gradually reduce the knife pressure with the screw (3) until compliance
5. Mount the bolt (2) back again.
Service Instructions 52Xi, 52Xi-75 - 00.0 - 11/2021
Thread trimming
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before checking and setting .
②
①
that the resistance against the knife motion is high within the whole
motion path.
with the proper setting is achieved.
③
(3) - Screw
47