Thread trimmer
13 Thread trimmer
13.1
Fig. 67: Adjusting the height of the thread-pulling knife
(1) - Counter blade
(2) - Thread-pulling knife
The height of the thread-pulling knife is factory-set so that the distance
between the thread-pulling knife and the middle part of the hook is 0.3 mm.
Proper setting
The thread-pulling knife (2) pivots as closely as possible above the hook
and is at the same height as the counter blade (1).
To adjust the height of the thread-pulling knife:
1. Open the throat plate slide.
2. Loosen the screw (3).
3. Move the thread-pulling knife (2) in such a way that the distance
4. Tighten the screw (3).
Service Instructions D869 e-con - 00.0 - 09/2023
WARNING
Risk of injury from sharp and moving parts!
Cutting and crushing possible.
Switch off the machine before adjusting the thread
trimmer.
Adjusting the height of the thread-pulling knife
①
②
between the thread-pulling knife (2) and the middle part of the hook
is 0.3 mm.
(3) - Screw
A
- Distance
③
A
81