Reading An Emergency Image Plate - AGFA CR 25.0 User Manual

Reading an emergency image plate

You may have an image plate which you wish to give priority over other image
plates which are being processed by the image processing station. Such image
plates are referred to as 'emergency image plates'. The actual workflow depends
on the configuration of your system.
Reading an emergency image plate in the interchangeable configu-
ration
In the interchangeable configuration, you can treat either:
◆ emergency image plates with ID data via the Emergency key on the keypad;
◆ emergency image plates without ID data via the emergency buttons at the
front of the
Reading emergency image plates with ID data
To read an emergency image plate with ID data:
1 Make sure the cassette has been identified properly via the ID Station.
2 Check that the CR 25.0 is ready for operation:
• The CR 25.0 must display the operator main screen with 'Ready' status, e.g.:
QS not ready
CR 25.0
• The status indicator at the top of the CR 25.0 must be green and be lit constantly.
❖
The CR 25.0 is operational if the status field equals 'READY', even if status
messages of the destination are shown (e.g. 'QS not ready').
2312A EN 20040909
CR 25.0 .
Status field
READY
35