Reading An Emergency Image Plate - AGFA ADC Solo User Manual

Reading an emergency image plate

You may have an image plate which you wish to give priority over other image
plates which are being processed by the image processing station. Such image
plates are referred to as 'emergency image plates'. The actual workflow
depends on the configuration of your system.
Reading an emergency image plate in the interchangeable configu-
ration
In the interchangeable configuration, you can treat either:
emergency image plates with ID data via the Emergency key on the keypad;
emergency image plates without ID data via the emergency buttons at the
front of the ADC Solo.
Reading emergency image plates with ID data
To read an emergency image plate with ID data:
1 Make sure the cassette has been identified properly via the ID Station.
2 Check that the ADC Solo is ready for operation:
• the ADC Solo must display the operator main screen with 'Ready' status, e.g.:
VIPS not ready
ADC SOLO
• the status indicator at the top of the ADC Solo must be green and be lit constantly.
The ADC Solo is operational if the status field equals 'READY', even if status
messages of the destination are shown (e.g. 'VIPS not ready').
2301D EN 20040224
READY Status field
31