Club Settings Menu (5651565) - Precor Experience 600 Series Service Manual

DIAGNOSTIC TEST
INCLINE TEST
STOP KEY TEST
(1) Only included on products that have the ASL feature.
(2) Not included on the EFX600 series or TRM600 series products.

Club Settings Menu (5651565)

Service Access Code: 5651565 (see
Used to customize the equipment user interface localization, Workouts configuration, and
maintenance default settings.
menu: Club Settings (51765761) > DIAGS - CLUB SETTINGS
1
analog to digital converter
2
Upper PCA board
3
Lower Printed Circuit Assembly board; also refered to as the Lower PCA or simply as the
lower board. On treadmills, it is the console to base function interface and the motor con-
troller unit (MCU). On self-powered units, it is the lower PCA console to base function inter-
face.
4
Emergency Stop: Safety clip and lanyard attached to the stop switch to immediately turn
off power bringing the treadmill to a stop.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
TEST DESCRIPTION
menu: MACHINE TEST > INCLINE TEST
Test parameters:
1
• A/D - lift motor incline position potentiometer A/D number.
• SEC - UP/DWN command response delay between the
2 3
UPCA and LPCA .
• Glitches - Momentary failures in the A/D potentiometer out-
put. If there are more than 50 Glitches, the lift motor should be
replaced.
.
menu: MACHINE TEST > STOP KEY TEST
(P10, P30 consoles only)
Verifies the Stop Key and E-Stop function
Test sequence steps:
1. StopKey test - Press the Stop Key
4
2. Lanyard ESTOP
gency stop function.
3. Exit test - Press the Stop button to reset and exit test.
"Service Menu Access Codes" on page
4 Standard Service Menus
LED Console Standard Service Menus
test- Pull the lanyard to trip the emer-
27)
Page 38