Precor Experience 600 Series Service Manual page 47

DIAGNOSTIC TEST
KEYBOARD TEST
1
PVS KEY TEST
HEART RATE
ACTIVE STATUS
(1)(2)
LIGHT
AS LIGHT
(1)(2)
BRIGHTNESS
3 (2)
MC LIGHT
BELT SPEED TEST
AUTO STOP TEST
1
Personal Viewing System display.
2
Active Status Light: Service and maintenance status light.
3
Motor controller, motor controller unit, or motor controller module: used on treadmills, con-
tains the LPCA and motor controller functionality.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
TEST DESCRIPTION
An illuminated LED map of the function keys will be shown.
Press each individual key and verify that the corresponding
LED extinguishes. Press and hold BACK to exit the test.
Not used, OEM test.
Tests the unfiltered and filtered pulse heart rate. Grasp the
grips to test the handheld heart rate. Use a Polar heart rate
simulator to test the wireless heart rate. Press the BACK but-
ton to exit this test.
2
The current ASL status light state (blue. pulsing blue, yellow,
& pulsing yellow).
Sets the ASL light brightness level and ON/OFF state: HIGH.
MED, LOW, and ON/OFF.
Machines with ASL functionality
Indicates the current fault status of the MC:
Green - OK
l
Yellow: Fault condition
l
Hold the Quick Start hardkey to reset.
Machines without ASL functionality
Used as an ON/OFF light:
menu: MACHINE TEST > BELT SPEED TEST
Tests belt operating condition in 0.1 speed increments
Test parameters:
• AMPS IN: Treadmill input Current.
• VOLTS IN: Treadmill input Voltage
• VBUSS: Treadmill internal buss Voltage
• AMPS MTR: Current supplied to the drive motor.
menu: MACHINE TEST > AUTO STOP TEST
Test parameters:
• Status - Exerciser detected on or off the running belt.
• Step Count - Average # of footplants. Footplant averaging
delay reset with each speed change.
.
4 Standard Service Menus
LED Console Standard Service Menus
(2)
Page 37