Precor Experience 600 Series Service Manual page 115

4. Disconnect the two brown wire input power connections (or two brown and two blue
wire connections for the 240 Vac option) on the ON/OFF SW Circuit Breaker
"" on page 102.
5. Remove the two #2 Phillips fasteners and remove the ON/OFF SW Circuit Breaker
. Retain part(s) and/or fastener(s) for installation.
Installation Instructions
1. Reinstall the ON/OFF SW Circuit Breaker
fasteners.
2. Reconnect the two brown input power wires (or two brown and two blue for the 240
Vac option) on the ON/OFF SW Circuit Breaker
3. Reinstall the Power Entry Assembly bracket
fasteners. Make sure that the wire cables are not pinched or damaged during install-
ation.
4. Reinstall the hood cover, see
5. Connect the power cord and switch the ON/OFF SW Circuit Breaker ON.
6. Do the Operation Verification tests (see
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
ON/OFF Circuit Breaker Switch Replacement
and secure using the two #2 Phillips
and secure using the four #3 Phillips
"Hood Cover Replacement" on page
"Operation Verification" on page
6 Replacement Procedures
, see "" on page 102.
82.
, see
23) and
Page 105