Precor Experience 600 Series Service Manual page 86

WARNING: Keep hands and appendages clear of the lift platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
1. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
2. Remove the support stands and clear any other items that might either block the
treadmill from lowering or may be damaged as it lowers.
3. Lower the incline to level "0".
Side access
This method accesses the lift platform assembly and connected hardware by laying the
treadmill on its side.
Laying the treadmill on its side
1. Toggle the power switch from OFF to ON. This will reset the incline level to "0" (the
incline level "Home" position). Incline level "0" is also the lift motor calibration ref-
erence incline level.
IMPORTANT: It is important to set the incline level to "0" (calibration ref level)
before switching the power OFF.
2. Switch the power OFF and unplug the power cord. Move the power cord so it will not
be damaged as the treadmill is laying on its side.
3. If not already removed, remove the Hood cover
page 82.
4. Clear the area of any obstructions or items that could damage or be damaged as the
treadmill is tipped on its side.
5. Tip the treadmill on its side while being careful to not damage or break off the rear lev-
eling foot. You can use soft blocking material next to the leveling foot to support the
frame weight as the treadmill is being tipped over.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
5 Adjustment Procedures
Lift Motor Calibration
"Hood Cover Replacement" on
Page 76