Precor Experience 600 Series Service Manual page 114

ID
Power Entry Assembly Bracket
Removal Instructions
1. Switch the power OFF and
TIP: For easier access, raise the incline to maximum before removing power.
Access the service Hardware Validation (51765761) and use the
CROSSRAMP/INCLINE Test to raise the incline and then remove power.
2. Remove the hood cover, see
3. Remove the four #3 Phillips fasteners and remove the Power Entry Assembly bracket
. Hold the bracket while removing to prevent wire cable damage. Retain part(s)
and/or fastener(s) for installation.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Description
Power Cord Inlet Assembly
ON/OFF SW Circuit Breaker
1
unplug
"Hood Cover Replacement" on page
ON/OFF Circuit Breaker Switch Replacement
the power cord.
6 Replacement Procedures
82.
Page 104