Precor Experience 600 Series Service Manual page 158

4. Hand start and reinstall the left and right 5/16" hex key running belt tension adjust-
ment bolts and washers. Continue tightening bolts until snug and stop.
5. Tension the running belt to specification and verify alignment and tracking, see
ning Belt Tension and Tracking Adjustment" on page
6. Reinstall the left and right Trim End Cap covers, see
ment" on page 88.
7. Reinstall the left and right Landing Trim covers, see
ment" on page 80
page 80.
8. Do the Operation Verification tests (see
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
and hood cover, see "Covers and Panels Replacement" on
"Operation Verification" on page
6 Replacement Procedures
Take-up Roller Replacement
62.
"Trim End Cap Covers Replace-
"Covers and Panels Replace-
23) and
"Run-
Page 148