Precor Experience 600 Series Service Manual page 132

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
2. Remove the MC, see
3. Use a #2 Philips screwdriver to remove the one MC top cover screw fastener
4. Use a small standard screwdriver to release the four mounting tabs and carefully lift
the MC top cover from the main housing. Disconnect the fan power cable connector
and remove the top cover. Place the top cover on a level work top. Retain fastener for
installation.
5. Use a #2 screwdriver to remove the four fan screws and remove the fan grill
Retain grill and fasteners for installation.
6. Carefully lift the fan
connector through the cable routing opening while removing. Discard the fan.
Installation Instructions
1. Make sure that the replacement fan is the current part number
(PPP000000304461101), refer to service bulletin
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
2
Treadmill
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1
unplug the power cord.
"Motor Controller (MC) Replacement" on page
and remove from top cover
6 Replacement Procedures
Motor Controller Fan Replacement
107.
. Guide the power cable and
2
SB.TRM .20161014.
.
.
Page 122