Table of Contents
Advertisement
Logging into your Gateway's UI
To manually configure the SmartRG Gateway, you must access the gateway's embedded web UI.
1. Open a browser and enter the gateway's default address (usually http://192.168.1.1) in the address bar. The Authentication
Required dialog box appears.
2. Enter the default username and password (usually admin/admin) and click
Note: The gateway's UI can be accessed via the WAN connection by entering the WAN IP address in your browser's address bar and
entering the default username and password: support/support. WAN HTTP access control MUST be enabled to access the gateway's
UI via the WAN connection. For more information, see the
If your SmartRG gateway is configured for "bridge mode" (modem) operation, your PC will NOT be able to acquire an address via CPE
DHCP. Instead, manually configure your PC's interface with an IP address on the default network (e.g., 192.168.1.100).
The remainder of this guide is dedicated to a sequential walk-through of the gateway user interface. Screen captures are provided
along with descriptions of the options available on the pictured page. Where applicable, valid values are provided.
For in-depth "how-to" information for specific scenarios, go to the knowledge base found on our support web site. Access to this site is
restricted to SmartRG customers and partners. Do not share links to this site with your subscribers.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2019
OK
. The Device Info > Summary page appears.
Management Access Control
section.
10
Advertisement
Table of Contents
