Table of Contents
Advertisement
3. If desired, click
Advanced IKE Settings
these settings, see
"Advanced IKE
4. Click
Apply/Save
to commit your changes.
The fields on this page are explained in the following table.
Field Name
Description
IPSec Connection Name
Enter a descriptive name for this connection.
NAT Transversal
Click to enable the NAT traversal protocol.
Select the IP version for this connection. Options are IPv4 and IPv6 . The default is IPv4 .
IP Version
Tunnel Mode
Select the encapsulation method to be used.
WAN Interface
Select the interface for the local gateway.
Remote Security Gate-
Enter the WAN IP for the tunnel.
way
To allow anonymous connections, click the
LAN-side VPN
Select whether to allow access to the entire LAN or a single host for local IP addresses.
IP Address
Enter the IP address for local access.
Mask or Prefix Length
Enter the subnet mask or prefix length for the IP address entered for local access, e.g.,
255.255.255.0.
LocalID Type
Select the type of ID for the local VPN. Options are Default, Domain, and E-Mail. The default
is Default.
When you select Domain or E-Mail, the
Remote-side VPN
Select whether to allow access to the entire LAN or a single host for remote IP addresses.
IP Address
Enter the IP address for remote access.
Mask or Prefix Length
Enter the subnet mask or prefix length for the IP address entered for remote access, e.g.,
255.255.255.0.
Remote ID Type
Select the type of ID for the remote VPN. Options are Default, Domain, and E-Mail. The
default is Default.
When you select Domain or E-Mail, the
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2019
to select Phase 1 and Phase 2 specific parameters. For detailed information about
Settings".
AH: Use this mode to encapsulate a packet with AH and IP headers. For authen-
l
tication, the entire packet is signed.
ESP: Use this mode to encapsulate a packet with ESP and IP headers. An ESP trailer is
l
added to the packet for authentication and integrity. This is the default.
Subnet: Allows access to the entire LAN. Enter the IP address and mask or prefix
l
length for the VPN.
Single Address: Allows access to a single host. Enter the IP address for the host.
l
Subnet: Allows access to the entire LAN. Enter the IP address and mask or prefix
l
length for the VPN.
Single Address: Allows access to a single host. Enter the IP address for the host.
l
Anonymous
checkbox.
ID Content
field becomes available. Enter the ID.
ID Content
field becomes available. Enter the ID.
90
Advertisement
Table of Contents
