Table of Contents
Advertisement
Field Name
Description
OBSS Coexistence
Coexistence of Overlapping Basic Service Sets (OBSS) prevents overlapping in the
20 MHz and 40 MHz frequencies. Options are:
Select whether to turn on power-save mode. Options are Disable and Enable . For
RX Power Chain Save
the 5 GHz band, the default is Disable . For the 2.4 GHz band, the default is
Enable .
Note: Before setting this parameter, set
RX Power Chain Save
Enter the delay time (in seconds) between when system activity ceases and
power-save mode engages. Options are 0 - 2147483647 seconds. The default is 10
Quiet Time
seconds.
RX Power Chain Save
Enter a throughput threshold (in seconds) for when the router engages power-
save mode after the quiet time seconds have elapsed. Options are 0 -
PPS
2147483647 packets per second. The default is 10 seconds.
This options is set to 6 Mbps for the 5 GHz band and to 1 Mbps for the 2.4 GHz
54g™ rate
band, and cannot be changed.
Multicast rate
Select the desired packet transmit rate for multicast.
For the 5 GHz band, the options are Auto and 6 - 54 Mbps. The default is Auto.
For the 2.4 GHz band, the options are Auto and 1 - 54 Mbps. The default is Auto.
Select the basic rate. Options are Default , All , 6 & 12 Mbps , and 6 &12 & 24
Basic Rate
Mbps . The default is Auto .
Fragmentation
Enter the size at which packets will be fragmented into smaller units. The
Threshold
primary consideration for this setting is the size/capability of the circuit. Options
are 256 - 2346 bytes. The default is 2346 bytes.
Note: A high packet error rate is an indication that a slightly increased frag-
mentation threshold is needed. When possible, the default value of 2346 bytes
should be maintained. Poor throughput is a likely result of setting this threshold
too low.
RTS Threshold
Enter the RTS (Request to Send) packet size beyond which the WLAN client hard-
ware invokes its RTS/CTS mechanism. Smaller packets will otherwise be sent not
using RTS/CTS. Options are 256 - 2347 bytes. The default is 2347 (disabled).
DTIM Interval
Enter the Delivery Traffic Indication Message (DTIM or Beacon rate) countdown vari-
able used to indicate when the next window is available to client devices for
listening to buffered broadcast and multicast messages. Options are 1 and 65535 .
The default is 1 .
Beacon Interval
Enter the time interval (in milliseconds) between beacon transmissions. Beacon
transmissions make known the presence of an access point and convey to wireless
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2019
Disable: The gateway advertises and operates in 40 MHz mode regardless
l
of what other networks are configured nearby. This is the default.
Enable: The gateway automatically reverts to 20 MHz channel bandwidth
l
when another WiFi network within 2 channels of its own channel is detec-
ted or when a client device with its 40 MHz Intolerant bit set is detected.
802.11n/EWC
to Auto.
118
Advertisement
Table of Contents
