Editing The Curvepoints - Siemens LMV27.100x2 Basic Documentation

26.11.8

Editing the curvepoints

To the next curvepoint
F
F
and
or
A
A
and
or
To the next curvepoint
170/219
Building Technologies
 Note
To check the change on the burner, a curvepoint change in the cold settings
necessitates a new approach of all curvepoints in the warm settings. After changing
the curvepoint, OFF UPr appears on the normal display of the AZL2.
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic Documentation LMV27...
26 Parameter level
or
The selected curvepoint is displayed.
%
Keep depressed.
F
The fuel actuator has been selected for
editing.
%
Keep depressed and press
F
adjust the fuel actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
Keep depressed.
A
The air actuator has been selected for editing.
%
Keep depressed and press
A
adjust the air actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
To select the curvepoint.
or
, the curvepoint is selected
F
or
, the curvepoint is selected
A
Back to the previous
curvepoint.
CC1P7541en
17.12.2018
to
to