Cold Settings For "G Mod Pneu", "Gp1 Mod Pneu" And "Gp2 Mod Pneu - Siemens LMV27.100x2 Basic Documentation

26.11.7 Cold settings for «G mod pneu», «Gp1 mod pneu» and «Gp2 mod
pneu»
Building Technologies
Note
Refer to chapter Warm settings for modulating mode («G mod», «Gp1 mod», «Gp2

mod» and «Lo mod»)! With no flame, however, no actuator travel and no automatic
operation after the settings have been made. Here, only the air requires adjustment
with .
A
If run is shown in the display, the following must be observed:
P
V h min s
Note!

You now have the option of pressing
the LMV27.
Basic Documentation LMV27...
26 Parameter level
Identification of start for setting the curve.
%
ESC
to continue with the cold setting for
169/219
CC1P7541en
17.12.2018