Warm Settings For "Lo 2 Stage" And " Lo 3 Stage - Siemens LMV27.100x2 Basic Documentation

26.11.11 Warm settings for «Lo 2 stage» and « Lo 3 stage»
Wait until the burner is operation and symbol
The startup sequence stops in Phase 36 Traveling to ignition position.
The ignition position can be adjusted under cold conditions.
A
and
or
Building Technologies
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic Documentation LMV27...
26 Parameter level
Identification of start for setting the curve
parameters.
%
Provided the load controller is
enabled!
/reset
Phase Standby (stationary)
%
Phase Fan ramp up (fan motor = ON, safety
valve = ON)
%
Phase Traveling to prepurge
%
Phase Prepurging
%
Phase Traveling to ignition
%
or is no longer highlighted!
Ignition position P0 can be set only when
symbol or
Keep depressed.
A
Press or
%
When symbol
the next curvepoint P1 can be selected with
.
position
position
is no longer highlighted.
to adjust the value.
or is no longer highlighted,
CC1P7541en
17.12.2018
175/219