L## Secure Door-Door Mode Definitions; L## Access Ctl Lvl; L## Chg Display; L## Chg Time/Date - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 2.0
Table 27: L## Secure Door-Door Mode
Definitions
Door State Definition
Lock Door Normal Door: When a door is in the
Lock Door state, one can initiate the
door sequence using Skeds, CYCLE
DOOR?, keypad functions, door
requests, and valid token or card
requests.
Secure No Access Allowed: When a door is
Door
in the Secure Door state, no access is
allowed through the door until it is
returned to the Lock Door state. The
Secure Door state includes Sked and
keypad functions.
Unlock Free Access: When a door is in the
Door Unlocked Door state, the door is
already shunted and the door strike
does not prevent the door from
opening. In this state, the user does
not need to activate a door request or
present a valid token or card.
Cycle Door
Momentary Access: This is a
temporary Door Mode in which the
door initiates the door sequence as if
a valid token or card was read. This
state occurs using the keypad and
remote programming software (RPS).
A sked cannot activate this state.

L## Access Ctl Lvl

Default: Refer to the program record sheet
Selection: Blank or E
Function No. Function Name
37 Access Control
Levels
Changing the Access Control Level in any
area affects all users and all doors
associated with that level for all areas.
Bosch Security Systems | 5/05 | F001U003636B
GV2MAIN
General Functions

L## Chg Display

Change the display (bright display, dim display, and
time display) in the area where this keypad is assigned.

L## Chg Time/Date

Change the date and time for the control panel in this
area.

L## Chg Passcode

Change a user pass code.

L## Add User

Alternate Keystroke
Add or change users, add or change authority levels,
(Menu function only)
add or change tokens or cards.
Default: Refer to the program record sheet
Selection: Blank or E
Function No. Function Name
15 Change Display
Default: Refer to the program record sheet
Selection: Blank or E
Function No. Function Name
16 Change Time and
Date
Default: Refer to the program record sheet
Selection: Blank or E
Function No. Function Name
17 Change
Passcodes
Default: Refer to the program record sheet
Selection: Blank or E
Function No. Function Name
18 Add User
9210 NOT READY appears if a door
controller is not assigned to the keypad
used to add or change tokens or cards.
Refer to CC# Assign Door in Section
2.10.1 Keypad (Command Center)
Assignment on page 45.
EN | 65
Alternate Keystroke
[COMMAND][4][9]
Alternate Keystroke
[COMMAND][4][5]
Alternate Keystroke
[COMMAND][5][5]
Alternate Keystroke
[COMMAND][5][6]