Log Threshold Reports; Rps Callback Reports; Rps Passcode; Log % Full - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 2.0
2.7.2

Log Threshold Reports

If communication with RPS is unsuccessful, or if no
phone number is programmed in
panel generates Log Threshold and Bad Call to Ram.
This indicates the log is filling and the control panel
cannot download its events.
RPS Ph
If there is no
generates the Log Threshold and Bad Call to RPS
Events immediately. Bad Call to RPS Events are
logged only locally. If an
control panel makes multiple attempts to reach RPS
before sending the reports. Refer to the
prompt in Section 2.7.3 RPS Callback Reports for an
explanation of dialing characteristics.
2.7.3

RPS Callback Reports

When dialing the RPS phone number, the control
panel makes two attempts to reach RPS. If the control
panel does not reach RPS on the first two attempts, it
waits 10 minutes then tries six more times with a 10-
minute interval between each attempt. One hour after
the last failed attempt, the control panel starts dialing
the RPS phone number again. It makes two more
attempts then waits 10 minutes and tries six more
times with 10-minute intervals between each attempt
before generating a Bad Call to RPS Report and
abandoning the effort.
Remote Program Dialing Exception: When an RPS
phone number is programmed, the user can call RPS
by entering [COMMAND][4][3] and pressing the
[NEXT] key until CALLRPS? is displayed. Press
[ENTER]. Only one attempt is made to contact RPS.

RPS Passcode

Default: 999999
Selection:
0 to 9, A to F
(six characters required)
Enter six characters. Do not use a space in the
passcode.
The control panel verifies the remote programming
software at the central station has valid access before
connecting using the RPS passcode.
Bosch Security Systems | 5/05 | F001U003636B
RPS Ph , the control
programmed, the control panel
RPS Ph is programmed, the
RPS Ph
GV2MAIN

Log % Full

Default: Blank
Selection:
1 to 99, or Blank
This parameter determines how full the memory log
can be before initiating a call to RPS at the central
station. This allows the central station to call the
control panel and copy the memory log before
messages are overwritten.
Blank disables the Log Threshold and Log Overflow
Events. These events are not entered in the log or
reported to the D6500/D6600 or the local printer.
The control panel continues to log events after the Log
Threshold Report is sent. When it reaches 100%
capacity (memory logger is full and previously stored
events are overwritten), the control panel generates a
local Log Overflow Event.
The control panel does not call RPS again until it
downloads the log and the Log % Full percentage is
reached. These events are also sent to the control
panel's event log and to the local printer(s) if installed.
The Log Overflow Event is not sent to the
central station unless Expanded Test Rpt
is programmed Yes.
EN | 29