Rps Call Back; Rps Line Monitor; Answer Armed; Answer Disarmed - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 2.0

RPS Call Back

Default: No
Selection:
Yes or No
Yes When the control panel hears the
correct RPS passcode, it hangs up the
phone, seizes the phone line, then dials
the programmed RPS phone number
(refer to the
section). This ensures that the control
panel only communicates with RPS
units connected to the programmed
phone number.
No The RPS session starts immediately.
No call back is required. The control
panel can engage in RPS sessions
when called from any phone number
and a proper RPS passcode is
identified.
This function allows the control panel, after it verifies
the RPS passcode, to provide an additional level of
security by hanging up and dialing the RPS phone
number at the central station before allowing any
upload or download.
When using the RPS Call Back feature,
be sure to program the character "C" as
the last digit in the RPS phone number
when using DTMF Dialing.

RPS Line Monitor

Default: Yes
Selection:
Yes or No
Yes Allows the control panel to
communicate with RPS after the
answering machine answers the phone.
No
Use No if the control panel does not
share the phone line with an answering
machine.
This program item enables a control panel that shares
a phone line with an answering machine to
communicate with RPS at the central station, even
though the answering machine answers the phone.

Answer Armed

You must program
Disarmed . The control panel must be in the correct
armed state.
Bosch Security Systems | 5/05 | F001U003636B
RPS Ph
prompt in this
Answer
or
GV2MAIN
Program this item No if it causes false
seizures of the phone line or if you do not
use RPS. This indicates that a device
using the same frequency tone is also
using the phone line to which the control
panel is connected.
If RPS Call Back is programmed Yes, the
control panel hangs up the phone after
the RPS tone and a proper RPS
passcode is identified. It then calls the
RPS phone number.
Answer Armed
Default: Refer to the program record sheet
Selection:
1 to 15, or Blank
Blank No answer.
1 to 15 The control panel answers the phone
after the specified number of rings
when all areas are master armed.
Set the telephone ring counter to answer when all
areas are master armed. If any area in the control
panel is perimeter armed or disarmed, the Answer
Disarmed ring counter is used.
The remote programming software (RPS)
considers perimeter armed as a disarmed
state.

Answer Disarmed

Default: Refer to the program record sheet
Selection:
1 to 15, or Blank
Blank No answer.
1 to 15 The control panel answers the phone
after the specified number of rings
when any area in the system is in a
perimeter armed or disarmed state.
Set telephone ring counter to answer when any area is
in a perimeter armed or disarmed state.
The RPS considers perimeter armed as a
disarmed state.
EN | 30