User Interface; 2.11.1 Commands; 2.11.2 Keypad Selections - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 2.0
Custom function cannot be used to change
time (such as Daylight Saving Time). Use
Skeds S## Function Codes 13 and 14 to
adjust for Daylight Saving Time (refer to
S## Custom Function prompt in Section
5.2 Skeds on page 108.
Example 1
Execute the third function in a keypad menu function
list:
D1255 CDDE
D1260 C8C7C5
The custom functions in Example 1 are not
compatible between keypad types.
Example 2
Instant master Arm (CMD 11):
D1255 A11
D1260 A11
The custom functions in Example 2 are
compatible between keypad types.
The D9000GV2 control panel series uses
separate keystrokes to program the custom
functions that accurately represent the two
separate user interfaces, the D1255 and
D1260 keypads.
Custom functions written for the D1255
that use the [PREV], [ESC], and [NEXT]
keys do not work on the D1260.
Custom function written for the D1260 that
use the softkeys (located on the sides of
the keypad display) do not work when
executed from the D1255 keypad.
Bosch Security Systems | 5/05 | F001U003636B
GV2MAIN
2.11

User Interface

Define which functions can be used by each of the
fourteen user authority levels. Each user can be
assigned the same or different authority level by area.
The user has rights in the area where the keypad is
assigned, based on the authority level assigned to the
user's pass code for that area.
When the pass code is entered at the keypad, the
control panel checks the authority level. The control
panel executes the function only in areas where the
pass code has the authority to use the function.

2.11.1 Commands

Similar to command initiation used in other Bosch
Security Systems products, the Commands method
provides continuity in the arming commands across
product lines and makes an easy transition for dealers
using other Bosch Security Systems products. With
commands, the end user presses [COMMAND] and
then the numeral of the command to initiate. For
example, [COMMAND][2] arms the perimeter of the
area. Some prompts can be accessed only from a
menu. These prompts are indicated by (Menu
Function only). To access these functions, press
[MENU], enter the function number, and use the
[PREV] and [NEXT] keys to scroll through the
choices.
The D9412GV2/D7412GV2 Program Record Sheet
(P/N: F01U003635) lists the commands available with
the system. Command numbers are shown in the
column labeled Command. If a particular function
does not have a command number, it can be accessed
only through the Function List.
If you plan to use only commands to operate the
system, and to arm and disarm by entering a pass
code, you do not need to program Custom Function or
Function List.

2.11.2 Keypad Selections

Programming choices in this section determine if
keypad functions are disabled (blank), enabled (E), or
restricted (P) panel-wide.
Press the [SPACE] bar to scroll through the selections.
Press [ENTER] when the correct selection appears in
the display.
EN | 54