Access Control Functions; Fire Test; Send Report; Door Control - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 2.0

Fire Test

Default: P
Selection:
Blank, E, or P
Function No. Function Name
12 Fire Test
Use this function to test 24-hour points in areas within
the scope of the keypad where the function is entered.
Controlled points, P## Type 1
using the Fire Walk Test Mode.

Send Report

Default: P
Selection:
Blank, E, or P
Function No. Function Name
13 Send Report
Use this function to test the communication link
between the control panel and the central station
receiver(s). It can send a Test Report or a Status
Report to the phone numbers programmed in
Routing. The Test Report includes additional
information if Expand Test Rpt
Section 2.1 Phone on page 9.

2.11.3 Access Control Functions

Door Control

Default: P
Selection:
Blank, E, or P
Function No. Function Name
14 Door Control
#14 Door Control [COMMAND][4][6])
This top level display must be enabled for the user to
access the cycle door, unlock door, and secure door
functions (refer to Section 2.11.4 Authority Level Selections
on page 61). Use this item when programming door
control in your function menu.
Bosch Security Systems | 5/05 | F001U003636B
GV2MAIN
Alternate Keystroke
[COMMAND][5][8]
, 2, 3, cannot be tested
Alternate Keystroke
[COMMAND][4][1]
or
[COMMAND][4][2]
is enabled in
Alternate Keystroke
[COMMAND][4][6]

Access Ctl Level

Default: P
Selection:
Blank, E, or P
Function No. Function Name
37 Access Control
Levels
Shows the current on or off state of control levels 1
through 14, pertaining to Access Control Only, (
Access Level L## Disarm Level
and
toggle levels on and off and invalidate access control
levels during an extended period. This change only
affects the user's token or cards; it does not affect
keypad Door Control functions.

Chg Display

Default: E
Selection:
Blank, E, or P
Function No. Function Name
15 Change Display
Use this function to select either a bright or dim
display with loud or soft keypad warning tones. You
can also choose the time and date display.

Chg Time/Date

Default: E
Selection:
Blank, E, or P
Function No. Function Name
16 Change Time and
Date
Use this function to set the time and date in the control
panel.
EN | 57
Alternate Keystroke
(Menu function only)
L##
). The user can
Alternate Keystroke
[COMMAND][4][9]
Alternate Keystroke
[COMMAND][4][5]