Uw# Sunday; Uw# Monday; Uw# Tuesday; Uw# Wednesday - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 5.0

UW# Sunday

Default: No
Selection: Yes or No
This prompt, and the next six day of the week
prompts, select the days of the week that the User
Group Window is active.
Refer to the W# Sunday prompt in Section
5.1.1 Opening and Closing on page 99 for
more information about programming this
prompt.

UW# Monday

Default: No
Selection: Yes or No

UW# Tuesday

Default: No
Selection: Yes or No

UW# Wednesday

Default: No
Selection: Yes or No

UW# Thursday

Default: No
Selection: Yes or No

UW# Friday

Default: No
Selection: Yes or No

UW# Saturday

Default: No
Selection: Yes or No
Bosch Security Systems | 5/05 | F001U003636B
RADXSKED

UW# Group Enable

Default: 00:00
Selection: HH:MM (hours and minutes)
This prompt must be programmed if this
User Group Window is assigned to a user
group.
Enter the time of day when the window starts.
Beginning at this time, users assigned to this window's
group can use their pass codes. The window goes into
effect at the beginning of the minute. Make entries
using a 24-hour clock (for example, 7:00 AM is
entered as 07:00, 2:45 PM is entered as 14:45).
Reboot the control panel to activate today's window.
The window needs to activate on the same day you
program it.

UW# Group Disable

Default: 00:00
Selection: HH:MM (hours and minutes)
This prompt must be programmed if this
User Group Window is assigned to a user
group.
Enter the time of day when the window ends. This
time marks the end of the period in which users
assigned to this window's group can use their pass
codes. The window stops at the end of the minute.
Make entries using a 24-hour clock (for example, 7:00
AM is entered as 07:00, 2:45 PM is entered as 14:45).
To disable the window, both the hours and minutes
spaces must be blank.
Do not program a single window to cross the midnight
boundary. The window stop time must be later than
the window start time.
EN | 107