S## Defer Test; S## Hourly Report; S## Defer Status - Bosch D9412GV2 Program Entry Manual

D9412GV2/D7412GV2 | Program Entry Guide | 5.0
Default: Blank
Selection: 1 to 11, 13 to 24, 28, 29
Test Report: This function emulates
9
the Send Report? keypad function.
This function generates a Test Report
only from Area 1 but contains panel-
wide status information. The report is
sent to the phone(s) programmed for
Test and Status Reports in Section 2.3.8
Dialing Attempts onpage 14.
Expand Test Prt
If
parameters is programmed as Yes, the
Test Report also includes all off-
normal states for events listed in
Diagnostic Reports and Test Reports
(refer to Section 2.3.8 Dialing Attempts
on page 14).
The Test Report can be deferred if any
other report was sent since the last Test
Report. To defer the Test Report,

S## Defer Test

program
The Test Report can be sent every
hour beginning at the time scheduled
S## Time
in . To send a Test Report
every hour, program
Status Report: This function generates
10
a Status Report for each area that is
enabled. The report is sent to the
phone(s) programmed for Test and
Status Reports in Routing.
The Status Report can be deferred if
any other report was sent since the last
Status Report. To defer the Status
Report, program
Bosch Security Systems | 5/05 | F001U003636B
Default: No
Selection: Yes or No
Enable sked to defer the Test
Report
in Phone
Default: No
Selection: Yes or No
Select Yes to send the Test
Report every hour.
.
S## Hourly Rpt
.
Default: No
Selection: Yes or No
Enable sked to defer the Status
Report.

S## Defer Status

.
RADXSKED
S## Defer Test

S## Hourly Report

S## Defer Status
EN | 111
Yes Defer the Test
Report.
No Send the Test
Report on schedule.
Yes Send the Test
Report every hour.
No Send the Test
Report only as
scheduled.
Yes Defer the Status
Report.
No Send the Status
Report on schedule.