Wait For "Parameter" Startup Data Set - Siemens SIRIUS M200D Manual

Functions
3.4 Fieldbus interface
Reference
For more information, refer to the documentation for your AS-i master.
Settings
Group diagnostics
3.4.3

Wait for "Parameter" startup data set

The user sets this parameter bit during configuration using STEP 7. It tells the motor starter if
a data set will be transferred. The motor starter waits for the "Parameter" startup data set for
3 minutes. If the transfer is not completed within this time, the starter signals the "Invalid
parameter value" fault. This fault is automatically acknowledged if the startup parameters
have been transferred without problems.
For more information, see Configuring/assigning parameters (Page 109).
Settings
Wait for "Parameter" startup data set
Note
This parameter can only be set using an AS-i parameter bit.
30
Device parameter
Device parameter
Default setting
enable
•
•
Default setting
No
•
•
M200D AS-Interface Standard
Manual, 08/2014, A5E02548958A/RS-AA/004
Setting range
block
enable
Setting range
Yes
No