Configuring/Assigning Parameters; Configuring; As-I Profiles - Siemens SIRIUS M200D Manual

Configuring/assigning parameters

5.1

Configuring

Configuring involves integrating the motor starter in the overall system by assigning
addresses and parameters.
Master requirements
The M200D AS-i Standard motor starter requires an AS-i master to AS-i spec. 3.0, with
master profile M4.
The table below lists AS-i masters that are M200D-compatible:
Designation
CP 343-2
CP 343-2P
DP/AS-i Link 20E
DP/AS-i Link Advanced
1) With the CP 343-2(P) and DP/AS-i Link 20E, the extended process image (analog data) is
accessed by reading a data set (data set no. 140-147; see the manual for the CP 343-2/Link 20E).
The extended process image can only be accessed directly via I/O addresses ("Cyclic analog
data") using the DP/AS-i Link Advanced.
For more details, please refer to Configuring on the DP/AS-i-Link Advanced (Page 110) in
configuration step 9, as well as the documentation for the master.
5.2

AS-i profiles

M200D AS-i Standard motor starters contain 2 independent AS-i slaves in a single
enclosure.
IO code
ID code
ID2 code
You can find the AS-i profile setting in Configuring on the DP/AS-i-Link Advanced
(Page 110).
You can find the data transfer assignments for the two slaves in Communication paths
(Page 66).
M200D AS-Interface Standard
Manual, 08/2014, A5E02548958A/RS-AA/004
MLFB
6GK7 343-2AH01-0XA0
6GK7 343-2AH11-0XA0
6GK1 415−2AA10
6GK1 415-2BA10
6GK1 415-2BA20
Slave 1
7
A
5
Remark
1)
1)
1)
As of firmware version V2.0
Slave 2
7
A
E
5
109