Siemens SIRIUS M200D Manual page 114

Configuring/assigning parameters
5.3 Configuring on the DP/AS-i Link Advanced
8. Slave 2:
To configure Slave 2, repeat steps 1 to 4.
Please remember that the AS-i addresses must be different.
9. Enter the following values for the AS-i profile:
10.Then enter the AS-i parameter bits listed below.
Slave 2 has now been configured as well.
114
Field Value
IO code: 7 (B B B E)
ID code: A
ID1 code: 7 (F); alternatively 6 or 5 depending on the PII setting
ID2 code: E
Field Value
P bit 0 0: Parameter echo = Messages/warnings
1: Parameter echo = Error/fault
P bit 1 —
P bit 2 —
M200D AS-Interface Standard
Manual, 08/2014, A5E02548958A/RS-AA/004