Mitsubishi Electric MELSERVO-J5 User Manual page 82

Device name
Electromagnetic brake
interlock
Limiting speed
Zero speed detection
Limiting torque
ABS transmission data bit 0
ABS transmission data bit 1
ABS transmission data ready
Malfunction/Warning
AL9F warning
Command pulse train input
permitted
General-purpose output A
General-purpose output B
General-purpose output C
Output device explanation
■ALM (Malfunction)
If the protective circuit operates and shuts off the base circuit, ALM will turn off.
If an alarm is not occurring, ALM will turn on in 2.5 s to 3.5 s after power-on (or in 3.5 s to 4.0 s for a multi-axis servo amplifier).
■INP (In-position)
If droop pulses are within the in-position range, INP will turn on. The in-position range can be changed with [Pr. PA10]. When
the servo motor is operated at low speed by increasing the in-position range, INP may remain on.
The device cannot be used in the velocity mode or torque mode.
■RD (Ready)
When the servo amplifier is switched to the servo-on state, RD switches on.
■SA (Speed reached)
At servo-off, SA is off. When the servo motor speed reaches the following range, SA turns on.
Set speed ± ((Set speed × 0.05) + 20) r/min (mm/s)
When the set speed is 20 r/min (mm/s) or less, SA is always on.
The device cannot be used in the position mode and torque mode.
For the MR-J5-_A_ servo amplifier, SA does not turn ON even when the servo motor speed reaches the set speed by external
force when both ST1 (forward rotation start) and ST2 (reverse rotation start) are off.
3 SIGNALS AND WIRING
80
3.5 Signal (device) explanation
Symbol Model
G A
P
 
MBR
 
VLC
 
ZSP
 
TLC
 
ABSB0
 
ABSB1
 
ABST
 
ALMWNG
BW9F  
 
PENS
 
DOA
 
DOB
DOC  
I/O signal
interface
type
S T
 
DO-1
 
DO-1
 
DO-1
 
DO-1
 
DO-1
 
DO-1
 
DO-1
 
DO-1
  DO-1
 
DO-1
 
DO-1
 
 
Detailed explanation
[G] [WG]:
Page 82 MBR (Electromagnetic brake interlock)
[A]:
Page 83 MBR (Electromagnetic brake interlock)
[G] [WG]:
Page 82 VLC (Limiting speed)
[A]:
Page 83 VLC (Limiting speed)
[G] [WG]:
Page 82 ZSP (Zero speed detection)
[A]:
Page 83 ZSP (Zero speed detection)
[G] [WG]:
Page 82 TLC (Limiting torque)
[A]:
Page 83 TLC (Limiting torque)
Page 83 ABSB0 (ABS transmission data bit 0)
Page 83 ABSB1 (ABS transmission data bit 1)
Page 83 ABST (ABS transmission data ready)
Page 84 ALMWNG (Malfunction/Warning)
Page 84 BW9F (AL9F warning)
Page 84 PENS (Command pulse train input
permitted)
Page 82 DOA (General-purpose output A)/DOB
(General-purpose output B)/DOC (General-purpose
output C)