Source I/O Interface - Mitsubishi Electric MELSERVO-J5 User Manual

Source I/O interface

For the servo amplifiers in this manual, source type I/O interfaces can be used.
Digital input interface DI-1
This is an input circuit in which the anode of the photocoupler is the input terminal. Transmit signals from a source (open-
collector) type transistor output, relay switch, etc.
For transistor
TR Switch
Approx. 5 mA
V ≤ 1.0 V
CES
I ≤ 100 μA
CEO
*1 For interfaces of the CN3-1 pin, CN3-10 pin, and CN3-19 pin of the MR-J5-_G_-RJ_, approximately 4.3 kΩ.
For interfaces of the CN3-16 pin, CN3-45 pin, and CN3-50 pin of the MR-J5-_A_-RJ_, approximately 4.3 kΩ.
For interfaces of the CN3-7 pin, CN3-9 pin, CN3-15 pin, and CN3-22 pin of the MR-J5W_-_G_, approximately 4.3 kΩ.
*2 It is 500 mA for the MR-J5-_A_.
Digital output interface DO-1
This is a circuit in which the emitter of the output transistor is the output terminal. When the output transistor is turned on, the
current flows from the output terminal to a load.
A maximum of 2.6 V voltage drop occurs in the servo amplifier.
Servo amplifier
DOCOM
*1 If the voltage drop (a maximum of 2.6 V) interferes with the relay operation, apply high voltage (a maximum of 26.4 V) from an external
source.
3 SIGNALS AND WIRING
100
3.6 Interface
Servo amplifier
EM2
etc.
Approx. 6.2 kΩ
DICOM
24 V DC ± 10 %
*2
300 mA
If polarity of diode is
reversed, servo amplifier
will malfunction.
ALM
Load
etc.
*1
24 V DC ± 10 %
300 mA
*1