Avaya S8300 Manual page 69

At the customer site
Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300
Media Server, 555-234-100, Issue 8, April 2005.
To upgrade the S8300, you complete selected tasks from Chapters 3 and 5. You
need to complete only some of the tasks in these chapters. The specific tasks are
identified by page number in the left-hand column. The subtasks to perform or skip
are listed in the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a
server — on the S8300, or on the primary controller for the S8300 (if the S8300 is
configured as an LSP). The headings below indicate on which of these devices the
task is performed.
1. If IA770 is in use (ICC
mode), get IA770 data
and stop IA770
Page 291.
2. Backup all system files
— translations, OS,
and security backup
sets.
Start on page 295.
3. Install pre-upgrade
service pack.
Page 298.
4. Install the new license
file.
Starting on page 299.
5. Install the new
authentication file.
Starting on page 300.
Task
On the S8300 (ICC or LSP)
Steps/Comments
ICC mode: These backup sets will not be
restored on the S8300B. They should be backed
up in case the S8300B is already in use, and it is
necessary to revert to the original configuration.
LSP mode: Backup only OS and security sets.
These backup sets will not be restored on the
S8300B. They should be backed up in case it is
necessary to revert to the original configuration.
You must install this service pack to enable the
Web Interface to upload and install the CM 3.0
software.
Issue 2 June 2005 69