Avaya S8300 Manual page 14

Converting an S8300 from ICC to LSP and upgrading Communication Manager from 1.x to 2.x
13. Set time, date, and
time zone.
Page 259.
14. Install post-upgrade
service pack file, if any.
Page 260.
15. Install the LSP license
file.
Starting on page 263.
16. Install the
authentication file.
Starting on page 264.
17. Configure server.
Starting on page 464,
ending on page 478.
18. Reboot the LSP.
19. Upgrade the gateway
Firmware.
Start on page 267.
14 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task Steps/Comments
The time of the LSP must be set to the same time
zone as its primary controller, even if the LSP is
physically located in a different time zone.
Fill in each Configure Server screen with data for
the LSP. Some of the configuration data will be
the same as that for the ICC.
On the Configure Local Survivable Processor
screen, select one of the three LSP choices
depending on the primary controller type.
Open a SAT session and enter reset system
4.
After the reboot, the LSP should be registered
with the primary controller and in a few minutes
translations should be synchronized.
Using the Avaya Installation Wizard on the
LSP's Web interface to upgrade the gateway
firmware is recommended.
Alternatively, you can use the MGP CLI
commands starting on page 298.