Avaya S8300 Manual page 30

Converting an S8300 from ICC to LSP and upgrading Communication Manager from 2.0.x to 2.x
1. Administer the primary
controller that the LSP
(after conversion) will use.
Start on page 157 if the
primary controller is an
S8300.
Start on page 163 if the
primary controller is an
S8700 or S8500.
2. Administer the media
gateway.
Starting on page 170.
3. Reassign endpoints from
the ICC to this primary
controller.
For information on updating
translations, see the
Administrator Guide for Avaya
Communication Manager,
03-300509.
4. Update the alternate
controller list on the
DHCP server.
See page 175.
30 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On the LSP's primary controller
Steps/Comments
Assign node names
Administer network regions
Associate LSP with a network region
Administer the LSP screen
Add media gateway
Repeat for each gateway controlled by the current
ICC.
For this scenario, the gateway will not automatically
register with the primary controller at this point. Skip the
subtasks, Verify Changes and Save Translations in this
section.
When the gateway finally registers, the media modules
will automatically populate, unless you are doing
administration without hardware (AWOH). In this case,
you will have to enter the media module types for each
slot.
Update translations — add stations and trunks.
If the primary controller is a new installation, using
the Avaya Installation Wizard and the Electronic
Pre-Installation Worksheet (EPW) is recommended
Alternatively, use SAT commands.
Place test calls to verify.
Reassign IA770 endpoints to the messaging
system used by this primary controller. Enter test
messages to verify.
On the DHCP server